Post Harvest Management of Horticultural Crops

Methods of wax application

Methods of wax application
Performance of waxing depends on method of application. Amount of wax applied and uniformity of application are extremely important. Fruits should be damp dry prior to wax application to prevent dilution. Waxes should never be diluted with water. The following methods are commonly used.
i. Spray waxing

This is most commonly used method. Fruits and vegetables which move on the roller conveyor are sprayed with water-wax emulsion. The waxed produce is dried in a current of air at 55°C. There are two types of spray waxing namely low pressure spraying and high pressure atomizing.

ii. Dipping

Here fruits are dipped in water wax emulsion of required concentration for 30 to 60 seconds. The fruits or vegetables could be waxed by keeping them in wire boxes holding about 100 fruits (30 kg) and dipping in 30 litre capacity tank containing wax emulsion. The fruits are then removed and allowed to dry under electric fan or in the open air or with warm air at 54 to 55°C. The produce should be turned periodically while drying.

iii. Foam waxing

Foaming is a satisfactory means of application because it leaves a very thin coating of wax on the fruit after the water has evaporated. A foam generator is mounted over a suitable brush head, and water is applied to the fruit or vegetable in the foam of foam. Spraying tends to waste wax, but it can be recovered in catch pans.

iv. Flooding

Flooding is similar to dipping and is a safe and convenient method of application.