Site pages
Current course
Participants
General
Topic 1
Topic 2
Topic 3
Topic 4
Topic 5
Topic 6
Topic 7
Topic 8
Topic 9
Topic 10
Topic 11
Topic 12
Topic 13
Topic 14
Topic 15
Topic 16
Topic 17
Topic 18
Topic 19
Topic 20
Topic 21
Topic 22
Topic 23
Topic 24
Topic 25
Topic 26
Topic 27
Topic 28
Topic 29
Topic 30
Topic 31
Topic 32
Topic 33
Topic 34
Topic 35
Topic 36
Topic 37
Topic 38
Topic 39
Topic 40
2.3.2 Methods of Measuring
Measurements are made with special measuring boards. Length measurements are usually made with the fish lying on its right side snout to the left, on a measuring board consisting essentially of a wooden or metal base carrying a centre scale and having a headpiece (nose block) against which the snout is to be pressed (Holden and Rait, 1974). The mouth of the fish should be closed, the fish body and tail are straightened along the mid-line and the readings are to be recorded from the scale. The measurements should be recorded to the nearest 0.5 mm with a fine draftsman dividers using a fresh fish in a near to relaxed condition as far as possible. Rays and other dorso-ventrally flattened fishes may be measured by lying straight on their ventral surface. Disc width rather than overall length is sometimes used as linear dimension of rays. Large fishes could be measured with calipers or from point to point along the body surface with a tape. If a fish is to be measured in centimeter units, a board with 1 m long is sufficient. For a larger specimen, an extension piece of 30 cm long can be clipped or hinged to the board. For fish measured in half-centimeter units, a board of 50 cm long is usually sufficient. The scale must correspond to the measurements being recorded. It is also not possible to measure fish to the nearest centimeter below on a board ‘marked 2 cm intervals’. Too many divisions in a scale will, either lead to mistake or waste time in recording characters to the nearest division. |