Site pages
Current course
Participants
General
Topic 1
Topic 2
Topic 3
Topic 4
Topic 5
Topic 6
Topic 7
Topic 8
Topic 9
Topic 10
Topic 11
Topic 12
Topic 13
Topic 14
Topic 15
Topic 16
Topic 17
Topic 18
Topic 19
Topic 20
Topic 21
Topic 22
Topic 23
Topic 24
Topic 25
Topic 26
Topic 27
Topic 28
Topic 29
6.3.2. Swept area method
6.3.2. Swept area method
Trawl net is a conical bag with a wide mouth fitted with otter boards for horizontal opening and floats and weights for vertical opening. This net sweeps the sea bed over a wide area. The tail end of the gear where the fishes are collected is called “cod-end”. Trawl nets dragged on the sea floor are called “bottom trawls”. The mean catch (either in weight or in numbers) put unit of effort or per unit of area is an index of the stock abundance. This index is converted into an absolute measure of biomass. This technique is called “swept area method”.
The trawl sweeps a well defined path, the area of which is the length of the path, times the width of the trawl called “Swept area” or “the effective path swept”.
The swept area ‘a’ can be estimated by following formula
a= v * t * h * x2
Where
V = Velocity of the trawl over the ground when trawling
h = length of head rope
t = time spent for trawling
x2 = wing spread as fraction of the head rope length (0.4 - 0.6)
When exact position of the start and end of the haul are available, the distance covered can be estimated by
D = 60 x $$\sqrt{{(Lat1-Lat2)^2}+{(Long 1-Long 2)^2}.\cos^2(0.5x(Lat 1+Lat2))}$$
Where D = Distance in nautical mile,
Lat 1 = Latitude at start of haul
Lat 2 = Latitude at end of haul
Long 1 = longitude at start of haul
Lang 2 = longitude at end of haul
Exact latitude and longitude values can be obtained from global positioning system (GPS), a simple electronic device.
If exact positions are not available, the distance covered for an hour can be calculated from
D = $$\sqrt{VS^2+CS^2+2*{VS}*{CS}*\cos{(dir V - dir C)}}$$
D = distance in nm
VS = velocity of vessel (knots = nm/hr)
CS = velocity of current (knots)
dirV = course of vessel (degrees)
dirC = direction of current (degrees)