Site pages
Current course
Participants
General
Topic 1
Topic 2
Topic 3
Topic 4
Topic 5
Topic 6
Topic 7
Topic 8
Topic 9
Topic 10
Topic 11
Topic 12
Topic 13
Topic 14
Topic 15
Topic 16
Topic 17
Topic 18
Topic 19
Topic 20
Topic 21
Topic 22
Topic 23
Topic 24
Topic 25
Topic 26
10.6.1.Extruder
Unit 10 - Methods of feed formulation and manufacturing
10.6.1.Extruder
- The extruder can be defined as a bioreactor where the raw materials are subjected to high temperature and pressure over a relatively short time.
- Feed ingredients are propelled along the barrel of the extruder by one or two screws.
- The mechanical screw action and the friction it creates, blends, shears, and cooks the material. (Held at 120-175ÂșC for about 30 seconds).
- At the end of the barrel, the mixture is forced through a die at high pressure; because of the difference the between pressure inside and outside of the barrel, the material expands.
- This sudden drop in pressure causes the water in liquid phase to change to the gaseous state producing what is known as expansion.
- As the steam escapes small voids are created which determine the cellular structure of the extrudate.
- The more cells the final product has, the less dense it becomes, and hence becomes a floating feed.
- If the cellular structure is more compact the final product is denser; therefore, heavier and can be considered a sinking feed.
- Floating feeds have a density that is usually below 450 g/l, while sinking feeds have densities above 550 g/l.
Last modified: Tuesday, 30 August 2011, 9:15 AM